压电驱动式药品输送泵的试验研究.pdfVIP

_______________________________________________________________________________ 压电驱动式药品输送泵的试验研究 阚君武，杨志刚，唐可洪，吴博达，程光明 （吉林大学 机械科学与工程学院，长春，130025） 摘要 为满足医学领域药品的精确输送，提出一种新的双压电薄膜驱动泵，并进行了试验研究。压电泵采用多层 粘结的圆片结构，包括PMMA 泵体、两个独立驱动的压电薄膜驱动器和四个弹性薄膜阀片。两个压电薄膜交叉工作 （即驱动相位相差 180°）时，每一个循环周期都有流体输出，脉动小。泵的输出性能取决于压电薄膜几何参数，利 用厚度0.18mm、直径50mm 的压电薄膜制作的试验样机具有自吸能力，可直接 （药液流经泵腔）或间接 （药液不经 过泵腔，利用空气压力使密封容器内流体输出）输送药液。在驱动电压80v、频率为20Hz 时，所获得间接/直接输送 流体最大流量分别为240ml/min 和55ml/min 、间接/直接输送液体的压力分别为6.15kPa 和8.1kPa。 关键词 压电泵，压电薄膜驱动，药品输送 Experimental study of a piezoelectric pump for drug delivery Kan Junwu, Yang Zhigang, Tang Kehong, Wu Boda, Chen g Guangming （College of Mechanical Science and Engineering , Jilin University ，Changchun 130022,China） Abstract ：A novel double-chamber piezoelectric pump is fabricated and tested to meet the demand of medical application. The pump is a multi-layer circular planar structure, consisting of PMMA pump body, two PZT actuator o membranes and four cantilever valves. The PZT actuators are driven at a phase difference of 180 . In this way, the liquid in chamber is continuously discharged in the flow direction and the p ulsation is decreased. The output performance depends on the geometrical parameters of actuator membrane. The prototype pump, fabricated with the PZT membrane of 0.18mm in thick and diameter of 50mm, can deliver drug directly (pumping liquid drug) and indirectly (pumping air to extrude liquid drug from a sealed container). For direct drug delivery and indirect drug delivery, the maximum flowrate achieved is 240ml/min and 55ml