PING不通的问题检查步骤（Check the steps for the pings）.doc

PING不通的问题检查步骤（Check the steps for the pings） The problem with Ping is that there are a lot of problems on the Internet, and it involves multiple devices, some of which may be configuration problems, some of which may be equipment problems. Check the following brief introduction of general steps, but these steps was only a matter of locating a framework, specific root tree network at that time and even your intuition in actual operation. The order of positioning also needs to be adjusted accordingly. The first thing to do is to eliminate some of the low-level problems The ping function is not supported by some equipment The ping message is filtered by the equipment 3 through some firewalls, or ASPF only supports one-way adoption 4 port configuration NAT First of all, we should use the division method to determine which equipment is out of question. 1 general IP forwarding can be used with tracert 2 MPLS VPN, which USES the method of ping to determine whether it is a private network device or a device in a public network. A common IP forwarding is blocked 1 check whether the routing table is normal The display IP routing is performed to view the routing information, and the filtering conditions can be used in the case of more routes. If there is no corresponding routing, it is necessary to check whether the configuration is correct, check the routing should be how to generate, root tree static BGP, OSPF, RIP protocol manual of fault location, query the specific reason. 2 check whether the transfer (FIB) is normal This step is easily missed, and the main control board and the business board are likely to be out of sync, so be sure to check the main control board and the business board (VIU/LPU) to be published (FIB) at the same time. If you find that the transfer is lost, please inform the relevant personnel in time to locate. NE05/08/16 Execute command display fib slot - number to view the table NE40/80 3 RPS performs display fib to view the tables Use the display t