单分模面注射模（Single die injection mould）.docVIP

单分模面注射模（Single die injection mould） The formula number expression parameter explains the knowledge point 5.1 -- number of cavity in each mold, one -- plan to produce the total amount of plastic parts - cost per hour of tooling, yuan/hour - molding cycle, hour - mold processing cost per cavity, yuan/unit The formula for determining the number of cavity in economy is 5.2.1 5.2 - the average pressure of the injector clamping force, N - cavity melt, MPa; - the projection area of the pouring system on the parting surface, mm; - the projected area of each plastic piece on the parting surface, mm2; The formula for determining cavity number is 5.2.1 according to the locking force 5.3 -- the maximum injection volume of the injection machine, g; - weight of single plastic parts, g; - the weight of the pouring system, g The formula of the number of cavity was determined by the amount of injection 5.4 - flow distance ratio -- the length of each section in the mould and the length of each section cavity, mm; - section thickness of each section of the mould and the sections of the cavity. The allowable flow distance ratio of plastic is shown in table 5.3 The check flow ratio is 5.3.1 5.5 -- the width of the large base of the trapezoid, mm; -- quality of plastic parts, g; - the length of the shunt channel, mm The wide margin of the trapezoidal section shunt is 5.3.3 5.6 -- the height of trapezoid, mm; -- the width of the large base edge of trapezoid, mm The height of the trapezoid section shunt channel is 5.3.3 5.7 - the width of the side gate, mm; -- the outer surface area of the plastic parts, mm2 The formula of side gate width calculation is 5.3.5 5.8 -- thickness of side gate, mm; -- the wall thickness of the plastic part of the gate is thick, mm The formula of side gate thickness calculation is 5.3.5 5.9 -- the area of the gate, mm2; - length of flow channel from main channel center to gate, mm; -- the length of the gate, mm The BGV value of the same plastic parts is 5.3.7 5.