标记方法（Marking method）.docVIP

标记方法（Marking method） Tire size marking method is traditional used two kinds of international standards, the traditional method is a minus sign connected the two Numbers to mark the tyre, the first set of figures show that the section width, the second group said rim diameter. If it is a radial tire side, the - that connects two sets of Numbers is usually replaced by an R letter. Since the original method of labeling originated from the United States, both sets of figures were expressed in British units, such as 9.00-20, 11.00 R22.5, 13.6-38, and 23.5-25, etc. In addition, some countries adopt the metric system or metric system, such as 260-508 pairs of Numbers are millimeters (mm), and the pre-185r15 Numbers are millimeters (mm), the latter is inches, etc. Because of the tire cross-section contour evolution and development continuously, the original traditional notation already can not adapt to the new requirements, so the international standard to tire cross-section width (mm), the structure of the tire is flat rate (%), code (e.g., R is for radial tire) and rim diameter symbol (in) the four said. The tire specifications generally still follow the traditional method of marking, using the main technical parameters of the outer tire. (1) skew tires The first set of Numbers indicates the width of the section, and the second group represents the rim diameter. Since the original method of labeling originated from the United States, both sets of figures were expressed in British units, such as 9.00-20, 11.00 R22.5, 13.6-38, and 23.5-25, etc. In addition, some countries adopt the metric system or metric system, such as 260-508 pairs of Numbers are millimeters (mm), and the pre-185r15 group Numbers are millimeters (mm), and the latter is in inches. This kind of specification is widely used in automobile tires, agricultural machinery tyres and engineering mechanical tires. In addition, there are several forms of expression: x to connect the diameter of the tyre and the widt