注塑机问题处理（Injection molding machine problem processing）.docVIP

注塑机问题处理（Injection molding machine problem processing） Incorrect operating conditions, damaged machines and molds will produce many molding defects. Some solutions are provided below for reference. In order to reduce the length of time, and to find out the cause of the operational problems as soon as possible, the operator should put all the best condition of injection molding machines are recorded in injection molding conditions record on, for future reference when solving problems. (1) finished goods not complete the cause of the problem processing method Plastic temperature is too low Improve the temperature of the melt shot rubber pressure is too low Increasing resin shoot shoot rubber pressure not enough resin increased shoot sprue bushing with nozzle is not straight, plastic leak To readjust its cooperation Before the time is too short Increase shoot rubber time shoot rubber speed too slow Speed up the shoot rubber low-pressure improper adjustment To adjust the mold temperature is too low Improve the mold temperature uneven mold temperature Reset mold pipe mold venting is not good Appropriate and moderate vent position Nozzle temperature is not low Elevating the temperature of the nozzle into the glue not average reopening mould overflow mouth position Runner or overflow mouth is too small Increase runner or overflow mouth Plastic lubricant is not enough to increase lubricant Back pressure is insufficient Slightly increasing back pressure aprons, wear plastic screw dismantle the check repair glue is enough Change of injection molding machine products of large size is too thin Using nitrogen shoot contraction (2) products, the cause of the problem mould into plastic processing method Melt enough Shot + melt glue pressure too low overhead pressure back pressure is not enough High back pressure gel time is too short Long shot time shot adhesive fast slow rate of overflow mouth imbalance Mould overflow mouth is too small or location The nozzle hole is too thin, pl