注塑速度（Injection speed）.docVIP

注塑速度（Injection speed） The ratio control of injection speed has been widely adopted by injection molding machine manufacturers. Although the computer control injection speed segmented control system already exists, but due to the limited information, the advantages of such machine setting are seldom used. This paper introduces the advantages of multi-speed injection molding system and describes its use in eliminating the defects of short shot, trapping gas and shrinkage. Z6, v2, E 3 O6 s ([ W I) K4 c The close relationship between the speed of injection and the quality of products makes it a key parameter of injection molding. By determining the filling speed of segmentation, the end of the beginning, middle, and implement a set point to the other a smooth transition of the set point, can guarantee the stability of the melt surface velocity to create the desired molecules get asked about the smallest internal stress. We recommend the following speed segmentation principle: 1) the velocity of a fluid surface should be constant. 2) it should be used to prevent the melt from freezing during injection. 3) the injection speed setting should take into account the rapid filling of the critical area (such as the flow path) and slow down at the inlet bit. 4) the injection speed should ensure that the cavity is filled immediately and stopped to prevent the filling, edge and residual stresses. The basis of setting speed segmentation must take into account the geometry of the mould, other flow constraints and unstable factors. The speed setting must have a clear understanding of the injection molding process and material knowledge, otherwise, the quality of the products will be difficult to control. Because the melt velocity is difficult to measure directly, it can be calculated by measuring the forward speed of the screw, or indirect calculation of the cavity pressure (to determine that