电机故障处理2（Motor failure treatment 2）.docVIP

电机故障处理2（Motor failure treatment 2） (1) the motor does not start 1. The power supply is not connected: check the switch, the melting wire, each pair of contacts and the motor lead the line head. 2. Winding circuit: the breaking parts heated to the temperature of the insulation class is allowed. The paint to soften, then break line start, with the same specification after repair welding of broken part, pack good insulation, then through painting, drying process. The winding ground or interphase and interturn short circuit: the processing method is the same, only the ground or the short circuit position is the insulation, then the coating is dried. 4. Error of winding wiring: check the wiring diagram, and repress the end of the wiring (including binding, insulation and painting) after heating the end part. 5. Melt burning: find out the reason, eliminate the fault, and the new melt according to the motor specification. 6. Error operation of winding rotor motor: check the position of collector ring short circuit and starting rheostat, and start with 0 series of resistor, and then the short circuit device after start-up. 7. Overcurrent relay setting value is too small: adjust height appropriately. 8. The old start switch oil cup is short of oil: add new oil and reach the oil surface line. Control device connection error: correction connection. (2) after the motor is connected to the power supply, the solution wire is burned 1. Single phase start: check the power line, the power line of the motor, the fuse, switch contact, find out the broken line or false connect to repair after the failure. 2. Fixed, rotor winding ground or short circuit: correct errors. 3. The motor load is too large or stuck: the load is adjusted to the rating, and the drag mechanism failure is ruled out. 4. The area of the solute is too small: the melt has no protective effect on the motor overload. In general, the melt should be selected according to the following type, the current of the melt is the