第四单元 点火系的检测与试验（Unit 4 test and test of ignition system）.docVIP

第四单元 点火系的检测与试验（Unit 4 test and test of ignition system） Unit 4 test and test of ignition system The detection of a traditional ignition system The purpose of practical training 1. Be familiar with the detection methods of ignition circuits and components. 2. Master the general method of fault diagnosis of ignition system. 2. Tool materials Complete car ignition circuit and corresponding parts. 2. Multimeter; Maintenance tools, etc. Iii. Operation points and projects 1. Composition of traditional ignition systems Figure 4-1 is the composition of the traditional ignition system. 2. Check for primary winding resistance. Short circuit, break, iron and overheat of primary windings can cause ignition systems to not work properly. Primary winding resistance is measured in multimeter. As shown in figure 4-2: If the multimeter indicates the value of infinity, the primary winding is broken. If the resistance value is less than the standard value, then there is a short circuit between turns. If the resistance value is normal in 1.2 ~ 1.7. 3. Check the resistance of the secondary windings Using multimeter, if the multimeter indicates an infinite value, the primary winding is broken. If the resistance value is less than the standard value or 0, there is a short circuit between turns. Its normal resistance is: 8 ~ 16 (with contact ignition coil) or 2.4 ~ 3.5. The parameters of the initial and secondary winding resistance of each model are shown in table 4-1 Table 4-1 resistance parameter table of ignition coil models resistance Liberation CA1090 Santana has contacts Santana has no contact Cherokee Primary winding resistance () 1.4 ~ 1.5 1.7 ~ 2.1 0.52 ~ 0.76 1.13 ~ 1.23 Secondary winding resistance () 6 7 ~ 12 2.4 ~ 3.5 7.7 ~ 9.3 4. Check the insulation resistance of the ignition coil The resistance of the ignition coil between the end and the shell should be infinite, otherwise the leakage fault should be replaced. 5. Check for additional resistance resistance The additional res