论楼板裂缝的分析和重点防治措施（On the analysis of floor cracks and key prevention and control measures）.docVIP

论楼板裂缝的分析和重点防治措施（On the analysis of floor cracks and key prevention and control measures） On the analysis of floor cracks and key prevention and control measures The cracks of cast-in-place reinforced concrete LouWu panel, is more difficult to overcome one of the common quality faults of especially residential engineering floor slab crack happens, often can cause complaints and disputes, and claims, etc. In this paper, my company ten years a large number of experiences and lessons in construction practice, as well as the processing of prevention, with emphasis on the design and construction is given priority to, give attention to two or morethings material analysis of the causes of the floor crack comprehensive prevention and control of and concrete measures. 1. Key strengthening areas in the design: From residential project site analysis of cast-in-place floor slab cracks occur, the most common, the most common and is the largest number of Yang Angle around the house room after leaving Yang Angle about 1 meter, namely in the floor of the separate reinforcement of negative moment reinforcement and radiation reinforcement end or the lateral Angle 45 ° around the floors of diagonal cracks. The reasons are mainly caused by the double action of shrinkage and temperature difference of concrete, and the closer the crack is to the roof of the roof. From the point of view of design, the current design standard focuses on the strength consideration, not adequately according to the temperature difference and the concrete shrinkage characteristic and so on a variety of factors for comprehensive consideration. And around the house Yang Angle due to the longitudinal and transverse shear wall or two direction stiffness of floor beam constraints, a relatively large limits the free deformation of concrete floor panel, so changes in temperature and concrete shrinkage, board face in the reinforcement is weak (i.e., in separate reinforcement of negative moment reinforcement and radiat