超声波无损探伤技术操作规程（Technical operation procedure of ultrasonic nondestructive flaw detection）.docVIP

超声波无损探伤技术操作规程（Technical operation procedure of ultrasonic nondestructive flaw detection） 1.1 equipment overview URP350, S type ultrasonic flaw detection equipment is to use the principle of ultrasonic detection tube inside and outside surface longitudinal, transverse defects and to measure the wall thickness of the steel a joint nondestructive testing equipment, its main flaw detection host, steel pipe conveyor system and water system SeBei composition and so on 1.2 main parameters 1.21 test tube diameter: 114 ~ 273.1 mm; 1.2.2 test steel pipe wall thickness: 4.8 ~ 25mm 1.2.3 surface temperature of steel tube: less than or equal to 80 degrees 1.2.4 length of pipe end blind area: less than or equal to 200m 2 safety confirmation and inspection 2.1 before operation, check whether all parts of the equipment are normal, but the task is not safe 2.2 no further operation of the crane 3. Operation procedure 3.1 pre-boot operation 3.1.1 with the diameter of steel tube, select the suitable wear-resistant contact boots and install them well 3.1.2 install the support arm to the correct height, and tighten the pivot bolt with the wrench 3.1.3 install the device in the correct position and tighten it 3.1.4 replace the casing ring with appropriate specification and lock it in the correct position 3.1.5 the scraping plate at the water entrance has been replaced with the appropriate specification 3.1.6 the correct tube diameter of the steel tube on the touch screen 3.1.7 the lifting platform has been moved to the correct height 3.1.8 check the calibration device has moved to the correct height, 3.1.9 inspection clamping roller has moved to the correct height 3.1.10 connect the water pump on the touch screen, 3.1.11 URP350 / S rotating head is either in the online position or in an off-line position 3.1.12 ensure that the off-line calibration device is compatible with the correct specification pipe diameter 3.2 the rotating head begins to rotate before rotation 3.2.1 Castell keys mu