酚醛板外墙外保温施工工艺（The process of external insulation construction of phenolic plate external wall）.docVIP

酚醛板外墙外保温施工工艺（The process of external insulation construction of phenolic plate external wall） This article is contributed by wangxiaoleibbm Doc documents may have a poor browsing experience at the WAP end. It is recommended that you choose TXT, or download the source file to the native view. Phenolic sheet external insulation system The construction plan Shanghai yajun decoration engineering co. LTD. Shanghai yada special coatings co. LTD 2011-3-29 The construction technology of PF external insulation bakelite plate (a) 1. Construction preparation The wall at the grass-roots level The basic wall should conform to the standard of GB50210, the standard of GB50210 Loose, dust, dirt and dissector are cleaned up, and the whole wall of the wall should be gouged or patched, and the connecting parts of the wall (equipment, pipe) are installed. The dimension deviation of the wall base of the external insulation construction shall be in accordance with the provisions of table 1. Table 1 on the surface of the wall base allows project dimension deviation Each layer of metope whole vertical masonry engineering degree is high surface roughness layer of 5 m or less work degree cheng all high surface smoothness of concrete of the vertical metope H / 1000 and thirty eight theodolite, steel rule check 2 m or less on feet and feeler check 5 m high 10 5 theodolite or messenger wire, steel rule 10 m 20 8 check 2 m by feet and feeler check 10 m or less theodolite or messenger wire, steel rule allow deviation, or less 5 mm test method 2 m line board check On the lightweight wall construction and transformation of external thermal insulation of existing buildings, external thermal insulation wall surface inspection, verification, by calculation to confirm it with the bond strength of phenolic board adhesive should be used. To 0.10 N/F = B * S acuity was type, F - its bond strength (N/was) B - wall at the grass-roots level and the measured bond strength of the phenolic board adhesive used