110吨电炉余热回收系统安全运行规程（Safety operation procedure of waste heat recovery system of 110 tons electric furnace）.docVIP

110吨电炉余热回收系统安全运行规程（Safety operation procedure of waste heat recovery system of 110 tons electric furnace） Safety operation procedure of waste heat recovery system of 110 tons electric furnace System input operation 1. Before the whole system starts, the on-duty operator will first check whether the manual valve is open, the liquid level of the drum and the accumulator is normal; Check to confirm whether the voltage and frequency conversion system of the fan is closed, and whether the control switch on the converter cabinet plate reaches the remote location, whether the water pump, valve, instrument control power supply is electric. 3, start the master control room computer, check whether the system is running normally, the display screen, flue gas and waste heat utilization process monitor screen (main), waste heat recycling test control screen, dust removal fan monitor screen, alarm screen, state parameter on the display of the data and instructions is normal, the switch button picture, can the mouse to click the corresponding button to enter and display; 4. In normal circumstances, all valves and water pump control in computer screen should be centralized (remote) control status; When the system is started, the furnace cover is in spiral. 6, first check whether the frequency converter is ready, no alarm signal transducer, trouble-free signal, no high voltage motor accident signal, click on start button of the computer screen, and the fan can be started, click the stop button, the fan stops running; 7, in the fan control screen there is a low frequency input window and a high frequency input window, good in advance to set the frequency, when electric furnace cover spin out, leaving the furnace, the fan to set low frequency operation, when the electric furnace cover screw in fan to set high frequency operation. When there is converter fault signal or inverter alarm signal, reset button, click on the picture can be reset to the frequency changer, start the blower, du