11塑料成型（11 plastic molding）.docVIP

11塑料成型（11 plastic molding） 1. Non-thermoplastic process performance is (hardening speed) 2. The characteristics of extrusion molding process do not include (can produce single parts) The main channel is usually cylindrical on the parting surface. The injection molding machine is suitable for injection molding (Angle injection machine). 4. The launching mechanism of the roll-out mechanism used for the center perforated round parts is (push pipe) 5. Inject thermoplastic plastic injection into boiling water, and make the normal time in the heating liquid medium or hot air circulation oven in the fixed temperature and then the treatment of slow cooling is called annealing (annealing). 6. The embedded parts are called (insert). 7. The plastic melt is directly entered into the cavity of the main channel, and the gate size is relatively small, and the flow resistance is only suitable for the gate of single cavity mold. An adiabatic flow injection mould of a single cavity is commonly referred to as a well - type nozzle. The plastic melt is directly entered into the cavity by the main channel and is much the same as the gate of single cavity mold. 10. The launching mechanism of the reposition rod is not needed when the module is closed (push piece board) 11. The plastic in the following plastic (amino plastic) belongs to thermosetting plastic. 12 in the inclined guide pillar side core-pulling mechanism, clamping lock after the slider and lateral parts of the thrust element is tight (偰 block) 13. After loading and closing, the plastic is melted and solidified by pressure heating. The molding method of the open die is taken out (compression...). Gate position should be open in plastic area. In the normal pouring system, you need to add a parting surface to the cast parts. 1. Fill in the blanks 1. The injection process generally consists of six steps: (addition material, plasticization, injection, pressure protection, cooling and ejection). 2. The simple launching agencies incl