交流接触器（Ac contactor）.docVIP

交流接触器（Ac contactor） Ac contactor is widely used as an open circuit and control circuit for electric power. It USES the main contact to open the closed circuit and USES the auxiliary contact to execute the control instructions. The main contact points usually only open the contact points, and the auxiliary contacts often have two pairs of contacts with normal and often closed functions, and small contactors are often used as intermediate relays in conjunction with the main circuit. The contact points of ac contacts, made of silver tungsten alloy, have good conductivity and high temperature ablation. Basic introduction 1. Basic composition The ac contactor consists of four parts: (1) electromagnetic system, including attracting coil, moving iron core and static core; (2) the contact system, including three main contact heads and one to two sets of regular open, often closed auxiliary contacts, is connected to the moving iron core. (3) the arc-extinguishing device, the general capacity of the communication contactor with large capacity is equipped with an arc extinguishing device, so as to quickly cut off the arc and avoid the contact of the main body; (4) insulation shell and accessories, various spring, transmission mechanism, short circuit ring, terminal, etc. 2. Working principle Lu: network transmission and distribution equipment Electromagnetic suction when energized coil, the static iron core, will be moving iron core and, as a result of the contact system is with the linkage of moving iron core, so core to drive three move contact run at the same time, the contact closure, and connected to the power supply. When the coil is out of power, the suction disappears, and the moving iron core is separated by the reaction of the spring. The main contact is disconnected and the power is cut off. 3. Use connection One: the general three-phase contactor has eight points, three input, three output, and two control points. The output and the input are corresponding, and its