冲压填空（Fill in the blanks stamping）.doc

冲压填空（Fill in the blanks stamping） The TXT is missing and dead. It is the highest level of murder. Even the medical examiner cant identify the cause of death... 1. Fill in the blanks 1. The working parts of blanking die are mainly convex, concave and convex. 2. According to the stamping process content of the die, the stamping mould can be divided into single process die, compound die and progressive die. 3. The basic parts of die for stamping die include the upper and lower module, guide column and guide sleeve. 4. The basic process of stamping processing can be divided into two categories. 5. In the assembly of the guide column and guide sleeve in the mould seat, the cooperative relationship should be used to cooperate. 6. Cold stamping process under normal temperature, on the pressure machine, using the mold to apply pressure to the material, to produce the separation or plastic deformation to obtain the necessary parts of a pressure processing method. 7. To make the cold stamping die work smoothly and smoothly, the axial line of the mould pressure center and the mold handle must be required to overlap (or not offset). The closing degree of a common crank press is the distance between the bottom and the surface of the work table when the bottom is fast. The closing height of the die is the distance between the upper plane of the die block and the lower plane of the die block when the die is in a closed state. 9. When selecting the pressure machine, the closing height of the die must be between the maximum closing height of the press and the minimum closing height. 10. The pressure machine with overload protection is the friction press. The adjustable punching machine is eccentric punch. 1. The blanking process includes two kinds of processes: blanking and punching. 2. The blanking deformation includes three stages of deformation process, namely the elastic deformation stage, the plastic deformation stage and the cutting and splitting phase. 3. The section of ordin