5D20机芯故障（5D20 machine core failure）.docVIP

5D20机芯故障（5D20 machine core failure） 5D20 movement related maintenance experience meta and change Standby (34SDDP, 29TJDP, said: R621 (29TIDP) between 1 and 2 feet.) and a 3.3K /0.25W resistance welding. Color flash (34SDDP) 1: change the digital board Y2 (20.25MHz). 2): change the power board D312 to 2DTV32. Red screen (machine produced before May 30, 2001): will be digital board C5, and a 1500PF/50V or 1000PF/50V capacitor. VGA Red Square: connect the C135 on the digital board with a 0.1uF capacitor. According to the program, the key / sometimes jump three channels: the replacement of CPU. STV9379 bad cause three noes: change C362 to 500V magnetic disk capacitor. Cold boot difficult: replace C954 (reset). AV color, DVD in any standard no color. After the image to the right 2: turntable three cm, color according to the video switch after normal: 1: the movement of the input signal to the more stringent requirements of AV, when the DVD is connected to a plurality of televisions, no color difference caused by the load capacity. 2: adjust data lines, N system adjustment is inappropriate, forced N system re search Taiwan, repeated switching. Sound intermittent: (29TFDP 29TJDP) and less Taiwan, there are two reasons: First: process quality problems. (C108 meets the sound meter shell, can solve separately) two: the circuit design question. 1): resistance R104A to 3.3K ohm /0.25W resistor, capacitor C104A instead of 15nF polyester film capacitor, CF103 instead of 6.5MHz filter. 2): disconnect the R104A C104A from the R104, plus the 55 foot of the fly line to the IC451. 3): change the DK HDEV in the factory data SERVICE OPTION2 from OFF to ON. 4): after the completion of the sound forced in the DK state. 5): replace the new version of the software CPU and the MSP3410 block. (or 3410, 37, 36, 33, 34 feet test. Note: connect with 4.7 F/50V.) ST92196A and ST92196B application difference: crystal oscillator and capacitor C952 and C953 are different, ST92196A is 82P, ST92196B is