木材表面处理（Wood surface treatment）.docVIP

木材表面处理（Wood surface treatment） Surface treatment of BBS: http://252/forum-117-1.html Wood oil wax A mixture of varnish and paint The hardness of wood wax is too low. Im not studying chemistry. I graduated from civil engineering, so its hard to analyze it in chemistry. I tried wood wax. Perception: the difference between polyester paint and nitrocellulose lacquer is relatively large. This property owner can apply, solid wood furniture glossiness is best adjusted to 5 cent light, big treasure paint, 3-4 cent light is more appropriate. As for why solid wood furniture is the best light, I am in the next [furniture item 1: McDonalds and heng jian will: how long can you sit?] Will be mentioned in subject a little grandstanding, mainly starts with the comfort that occupy the home, in colour, gloss, ergonomics analysis, why McDonalds chair, the music, the color is not suitable for sedentary, and design and production of solid wood furniture to how to avoid these problems. Hardness: the best way to demonstrate this is to use facts. I once told one of the owners that the hardness of red oak is much higher than that of the water. The hardness of the rubber wood is higher than that of the water. The landlord thinks that I am the owner of the melon. I went straight for the red oak and the water and the wood, which is the hard bone, right away. In the same way, I should judge the hardness of wood wax oil and polyester paint, nitrocellulose lacquer, the best way is to break each other, whos shallow, whose hardness is high. The results show that the difference in the performance of wood wax oil is very obvious. You can use your nails on wood wax to see if there is any. If this cant be satisfied, at least table, chair, sofa, desk and other furniture use wooden wax to do is not appropriate. Environmental protection: current polyester lacquer and nitrocellulose paint harmful material are unavoidable. But polyester lacquer is a bit better than nitrocellulose, because it can become lacq