机械设计经典填空题 附答案（The mechanical design of the classic fill-in-the-blank questions）.docVIP

机械设计经典填空题 附答案（The mechanical design of the classic fill-in-the-blank questions） Lesson two belt drive 1. In belt drive, the three stresses of the belt are stress, stress and stress. The maximum stress is equal to that the allowable stress in the belt is less than it will lead to Failure. 2. In belt drive, skidding means more on wheels. When it starts to slip, the relationship between the tightening tension F1 and the loose side tension F2 is:. 3. With drive and gear drive, the belt transmission should be arranged in gear transmission. When the drive center distance is arranged, the loose side should be placed on the side. 4. In the process of driving a transmission, the magnitude of the stress is subject to change, which is the maximum stress change, while the stress is not changed. 5. The transmission ratio should not be too large. If the transmission ratio is too large, the effective tension value will be reduced. 6. A V belt drive, take the cross section of A = 142 mm, produced by tension stress sigma o = 1.5 MPa, effective strain Fe = 300 N, excluding the influence of centrifugal force, tension side tensile Fl and loose force F2 = N and N, respectively. 7. Controlling the proper initial tension is an important condition for ensuring the normal operation of belt transmission. The initial tension is too large. The common belt tightening device is available. 9. The diameter of the grooved corners of the regular v-belt wheel is reduced. 10. When designing V belt transmission, the model of V belt is selected according to the selection. 11. The driving force cannot guarantee accurate transmission ratio, the reason is. 12. The design criterion with transmission is. 13. When designing V belt transmission, it is found that V has too many roots and can be used to solve it. 14. Belt transmission is avoided by causing elastic slip on the belt wheel during work. 15. With the drive method, the Angle alpha l of the small belt wheel is increased. 16. In other conditions, the re