纹波测量（Ripple measurement）.docVIP

纹波测量（Ripple measurement） Ripple measurement 71. The ripple of the switching power output voltage is an important indicator. How to use the oscilloscope correctly to measure this indicator? A: the definition of a ripple is a hybrid signal with Periodic And Random components attached to the dc level. Its defined as the peak value of the clutter. Note: the scope of the scope of the oscilloscope will bring a large ripple, and the geodesics should be used directly to measure the surface of the probe. Of course, the best method is to use 50 ohm resistor, with direct connection to the oscilloscope, BNC cable here should pay attention to the 50 ohm resistance to consider power consumption, is likely to be high power resistance. Relevant standard requirements, such as whether to divide periodic frequency ripple and switch ripple, high frequency noise, etc. For example, the measurement frequency should be limited to below 20MHz. 72. A large part of the measured ripple is a periodic spike of 50 Hertz. The larger the load current, the larger the pulse amplitude, and what are the specific solutions? Answer: in the power measurement system capability, when ripple measurement, we can choose to power frequency ripple or switch ripple testing, so that it can automatically filter out irrelevant frequency ripple, such as: choose the ripple test 200 KHZ, the oscilloscope will automatically to other frequency components in the filter. 73. How to remove the noise from the ripple when measuring the ripple, such as the noise of the work? A: the noise on the ripple can remove the random noise by capturing the high resolution capture mode in the capture mode through the TDS5000 oscilloscope. There are two kinds of ripple - frequency, 100HZ, and switch ripple. The TEKs TDSPWR2 can separate the two strands of grain into separate measurements. 74. Is it possible to accurately test the ripple and noise of switching power supply in a specialized laboratory? A: of course, it would be ideal to have