线数分别（Line number respectively）.docVIP

线数分别（Line number respectively） 1, the resolution is an important parameter of success for the camera, refers to when the camera intake arrangement between black and white stripes, such as the maximum number of lines on the monitors to the human eye can see, when more than a line number, can only see on the screen a grey one and cant distinguish between black and white lines. Clarity is divided into horizontal resolution and vertical resolution. 2, test methods, camera comprehensive test figure, with visual method to observe the wedge in the center of the image on the monitor center can distinguish the maximum number of lines or ten group definition line can tell the difference between the maximum number of lines. Be careful when testing (1) use the lens with good image quality because the quality of the lens affects the final test results. (2) is displayed using monitor, black and white line number should be in above of 600 line, if you are using a color monitor, the color saturation knobs will be dispatched to the lowest, avoid the chroma of luminance signal interference. 4. Pay attention when purchasing (1) using SONY and panasonic original camera to make horizontal comparison, observe the difference between the two cameras in distinguishing the black and white lines; The performance index of the original installed machine is true and reliable. By comparison, the correct conclusion can be obtained from the definition of the camera. (2) to buy veneer machine form a complete set, sometimes the lens of the imaging quality is poorer, besides resolution to test center, or testing the resolution of the four corners, cannot appear fuzzy and deformation, otherwise, the better the lens has to be replaced. Two, minimum illuminance index should have relevant condition 1. The concept of minimum illumination, the brightness output level produced by the camera, is the minimum illumination of the subject at the halfway point of the rated level (700mv). 2. Test method Level 10 gr