104规约说明（104 specification）.docVIP

104规约说明（104 specification） IEC - 870-5-10 4 specification The IEC - 870-5-10 4 statute is a network transmission remote protocol, which is based on network transmission. In general, The schedule calls for a long pass with a separate network, so it is generally required to configure a network card, the network of the network The address is typically specified by scheduling, such as 192.1.10.7. In addition, you will need to fill in the default gateway address, default network It is also specified by scheduling, such as 192.1.10.100. The network segment of the default gateway should be connected with the network address of the network card network The same. If you need to communicate with more than one dispatch, you need to write a batch file (*.bat), its contents Route add destination mask gateway (for example, route add 192.1.3.0 255.255.255.255.0 192.1.16) and add the file to the start - program - startup. Once youve configured your network card, You can do the following job. One. Configure TCPS or TCPC ports First, the C network segment or D net segment of the network node of is changed to the CCM interface - communication setting - communication interface The network section (e.g. 192.1.10.) is set in the network card, and the network address is filled in the corresponding network address bar. Second, if the native needs TCPS port (the machine as the server side, scheduling as the client), in the CCM interface - communication setting - communication interface - custom TCPS network port (TCP) to configure the number of corresponding network ports to fill in the native A/C network week The address of the address or the local B/D network is known as the Port number, which is recommended as a decimal system of 2404, or it can be adjusted A given), which network is specified based on the previous setting, which is known as the hexadecimal number of the address, and then the other The network address of the degree (given by the dispatcher) is filled in the corre