101常用命令格式（101 common command format）.docVIP

101常用命令格式（101 common command format） IEC 60870-5-101 common command format summary [please cancel automatic line wrap when browsing this document in a notepad; print out A3 paper just one] Shorthand notation The ADDR link address field, the substation RTU address. The value of the address domain is 0 to 255, of which 255 is broadcast address. TI Type Identification (Type Identification). It identifies the frame class as a telemetry frame, a remote letter frame, an electrical frame, or a call to a command, a confirmation, or a response. VSQ Variable Structure Qualifier D7 represents information body or element addressing method, and low 7 bits (D6 to D0) are the number of information bodies / / D7 = 0 information disorder, that is, the information body part is: address, element; Address, element; Address, element; ...... / / D7 = 1 information order, that is, only the first information body address, the rest add 1: address, element, element, element... Length frame Length (control domain, address domain, total number of bytes of user data), only appears in the variable frame Length frame format. Fixed frame length frame only 5 bytes (10?????? 16) COT transfer (Cause of Transmission) CS frame checksum (Check Sum) : the arithmetic of all bytes in the control domain, address domain, and user data (not to consider overflow, which is to take a low byte value) The low and high levels of the L H information address, such as 0B 0B01H Information address range: # code process: the master station and RTU communication started out as a master station requests a distance link-state, if RTU response link intact, master station to reset a distant link layer, and then the total call. 001H - 400H remote letter (1024), the main station has been requesting the state of distant link. The secondary data is always summoned when no special task is required, and the total call and electrical measurement are requested at intervals. 701h-900h telemetry (512) # will notify the main station wh