DA模块转换（DA module conversion）.docVIP

DA模块转换（DA module conversion） / / screw the potentiometer, will display values between 0-255 three digital tube. This is to convert analog voltage into digital signal. Some twist number may not / / dynamic digital potentiometer, please press the reset button S22 users can update the data on the experimental board This picture is the reason / / and AD chip some of its characteristics. #includereg51.h #include intrins.h #define uint unsigned int #define uchar unsigned char Uchar, A1, A2, A2t, A3, a, B, K, num, jiannum; Sbit adrd=P3^7; //IO port definition Sbit adwr=P3^6; Sbit diola=P2^5; Sbit dula=P2^6; Sbit wela=P2^7; Sbit light=P2^7; Sbit set=P3^4; Sbit shift=P3^1; Sbit jia=P3^2; Sbit jian=P3^3; Void, int0init () {TMOD=0x11; / / set the timer 0 mode 1 TH0= (65536-62500) /256; TL0= (65536-62500)%256; TH1= (65536-5000) /256; TL1= (65536-5000)%256; EA=1; / / open interrupt ET0=1; / / open timer 0 interrupt ET1=1; / / open timer 0 interrupt TR0=1; / / start timer 0 TR1=1; / / start timer 0 } Uint true; Uchar, Adval, adok, Xianshi, xiannum; Void delay (unsigned char I) / / delay procedures {unsigned, char, J, k; For (j=i; j0; j--) For (k=125; k0; k--); } Uchar code table[]={0x3f, 0x06,0x5b, 0x4f, 0x66,0x6d, 0x7d, / / digital encoding 0x07,0x7f, 0x6f, 0x77,0x7c, 0x39,0x5e, 0x79,0x71}; Void display (uchar bai_c, uchar sh_c, uchar g_c) / / display program {if ((xianshi==1) (xiannum==0)) {P0=table[bai_c]; / / display 100 Dula=1; Dula=0; P0=0xfe; Wela=1; Wela=0; Xianshi=0; Xiannum++; } If ((xianshi==1) (xiannum==1)) { P0=table[sh_c]; / / display ten Dula=1; Dula=0; Wela=0; P0=0xfd; Wela=1; Wela=0; Xianshi=0; Xiannum++; } If ((xianshi==1) (xiannum==2)) { P0=table[g_c]; / / display a Dula=1; Dula=0; P0=0xfb; Wela=1; Wela=0; Xianshi=0; Xiannum=0; } } Void (main) / main program {a=5; B=10; K=200; Int0init (); While (1) {if (set==0) { Delay (50); If (set==0) While (... Set); Jiannum++; If (jiannum=4) Jiannum=0; } //***************************** / reduction If ((shift==0) (jia==