ern（白尾海雕）.docVIP

ern（白尾海雕） SolidWorks draw the spring, SolidWorks how to draw the spring, SolidWorks spring Steps to create a spring Step 1 new parts Use the template Part - MM to create a new part, named 3D Sketch. Step 2 open a new 3D sketch Click the 3D sketch, select [insert] / 3D sketch from the drop-down menu, and open a new sketch. Step 3 draw the centerline In the sketch toolbar, click center line. Press the Tab key until the cursor is displayed as a YZ symbol. Start from the origin along the Y axis, draw the center line length is about 3mm, keep the line with Y axis in model space; along the Z axis for about second} 3mm center line length, keep the line with Z axis in model space; marked respectively the center line of the size of 3. 25mm and 3mm. Step 4 draw the first straight line Click the straight line button. Press the Tab key until the cursor is displayed as a XY symbol. Second from the center line of the end point to draw a straight line along the X axis was about lOmm long, keep the line with X axis in model space. Step 5 draw second straight lines Draw second straight lines of length about 3mm, with an angle of about 450 of the horizontal line. The symbol is the cursor said sketch and XY plane are drawing parallel, but yellow indicates that this line of reasoning is just a reference indicator, and did not add geometry. We will add parallel geometry in step 9. Step 6 switch the sketch plane Press the Tab key to switch to the YZ plane. Along the Z axis. Draw a line about 3mm long, keep the line in the model space and coincide with the Z axis. Step 7 view multi viewport In isometric 3D sketch shows clearly cannot view, when the user drags the sketch object when it is difficult to know the moving distance, which helps to solve this problem. In the standard view toolbar, click view orientation, and then click the four view. Step 8 drag the endpoint Public endpoint drag two lines, in the viewport, display second lines with angle deviation from the forward-looking datum i