互调失真（Intermodulation distortion）.docVIP

互调失真（Intermodulation distortion） Transient intermodulation distortion (referred to as TIM distortion), which was released publicly in 70s, is closely related to negative feedback. In the transient signal pulse input, the circuit capacitor sound output output voltage can not be due immediately, and the negative feedback circuit can not get timely response, AMP in open-loop state at this moment, the output moment overload causes clipping, the clipping distortion called transient intermodulation distortion, the distortion in the more serious on the amplifiers. Edit this paragraph principle As everyone knows, negative feedback (Negative Feedback) is the role of the inverted phase output value is negative, then the feedback to the input and the set value of subtraction, the error signal, then the controller will be made according to the size of the error correction, thereby greatly reducing distortion. But due to the negative feedback to the input signal and feedback output signal subtraction, reduces the signal level, when the negative feedback quantity to the output signal and the input signal is reduced to the same level, namely the whole line without amplification, this amplifier is a buffer amplifier (Buffer Amplifier), it has the advantages of high input impedance, low output impedance that is often used for impedance matching. If we want to make a larger output signal level, the amplifier gain should be increased, which in the tubes and transistors machine is not difficult. But the negative feedback can effectively reduce distortion, but the distortion caused by the new transient intermodulation distortion, the distortion in the transistor (stone) machine is the most serious. This is because the stone used up to the depth of about 50-60dB negative feedback to improve the stability and reduce the distortion, although this machine will easily obtain technical parameters of transistor high. But there is gain and loss, in order to reduce the depth of negative high fre