交换机设置（Switch settings）.docVIP

交换机设置（Switch settings） The first method of setting up a small switch Domestic small telephone exchange set almost the same, such as Ike switch, multichannel switch, TCL switch card, Lixin switches etc.. Enter the programming state first on the 801 switchboard (or 601, or 01 port): Ike TC2000 series machine *011234# dial, hang up. TCL ace AF series AT series lift, dial *011234#, hang up. Letter stand through LC-138 series lifting machine, dial *018888#, hang up. You have to enter the programming state to set the following functions! 1, extension number of shells (ie change extension number) The code is: 7 ABC ABC # (Lixin LC-138 * 6 ABC ABC #) ABC is the original number of the extension, and ABC is the new number of the extension (100-999). Note that the extension number you want does not depend on the number of the switch.! (#94 query extension physical principle number, #95 query extension physical principle number, pay attention to the number of beep sound. Low price with no voice cues 2, extension level settings Level 1 is unlimited, level 2 cannot dial international telephone, dial domestic telephone, level 4 cannot dial domestic telephone, dial local telephone, level 6 can only internal telephone * 51 * grade # extension. Such as: 802 extension set code for domestic and telephone: 8022 * 51 * # 3, relay outside open Settings Open first perimeter set code: * 3 (1-4, # outside end is outside the terminal number) 4, set outside lines, enter the bell settings * 1 outside the port number at the end of the original number of digits # (TCL ace outside port number is a number, the other is two digits) For example: first outside set code 802 extension Bell: * 1012 #: the first perimeter is 01 (TCL 1), at the end of 802 digits is 2 5, set an outside line into the computer voice prompt, set the code * 01-04 is 20 outside the port number # outside port number, TCL is 1-4 A computer voice prompt for all outside # * 20 6, set an outside line into the manual transfer mode (ou