深入探讨FUJI可编程序控制器MICREX-F70系列.pptVIP

FUJI 可编程序控制器MICREX-F70 系列 实现高速处理 装有高速专用LSI，实现基本指令和应用指令的高速处理 拥有种类丰富的功能模块 完整的处理器模块支援 系列模块都按标准有单个T-LINK遥控I/O链系统 操作环境 标准的windows界面,操作方便,程序编制简单易懂 系统配置类型 独立系统 分散/扩展系统 T-link slave 系统 Data-link 系统 T-link 系统 T-link 系统 P-link 系统 PE-link 系统 ME-NET 系统 JEMA-NET 系统 场桥系统图 特殊规格的模块 一 ETHERNET 模块 二 RS232 模块 型号 NC1-ET1 硬件设置 a) IP 地址设置开关（IP address setup switch) b) 状态设置开关 （Status setup switch) 指示灯含义 主要参数设定（同CITECT组态软件有关) 1） 本机IP地址的设定 2）本机所连PC机的 3）所连PC机的IP地址的设定 4 ) 所连PC机的所连PC机的 5. 遇到故障时的检查方法 ETHERNET模块 IP address setup switch The low-order 2 digits of the IP address in this module can be set using Hexadecimals. Set the high-order 6 digits of the IP address in the initialization Processing parameter area. IP address configuration. ﹢ ﹢ IP address setting switch High-order 4 bits (0 to f) Low-order 4 bits (0 to f) Parameter setting for initialization The default setting of this switch is ooh. 31 23 15 7 3 0 Status setup switch Sets loop-back test Off: normal operating mode On: loop-back test mode Loop back test SW4 Not used SW3 Enables or disables data write operations from other nobles to PLC internal memory. On: write operations from other nodes disabled. Off: write operations from other nodes enabled. CPU line timing setting SW2 Sets: line process when a TCP time-out error occurs. Off: line closes when a TCP time-out error occurs. On: line stays open when a TCP error occurs. Selecting line processing TCP time-out error setting SW1 Description Setting item Switch The default setting for all switches are 0. Selecting line processing when TCP time-out error occurs(SW1) When the set number of retries fails to receive an ACK response during TCP/IP protocol transmission, a TCP time-out error is generated . this switch allows you to select how this situation is to be handled. 指示灯含义 Connection status of connectio