rman备份恢复（RMAN backup recovery）.docVIP

rman备份恢复（RMAN backup recovery） RMAN backup recovery -- backup of RAC environment database (four) =========================================================== Author: yangtingkun () Published at 16:49 at 2007.05.17 Category: ORACLE Source: /post/468/288295 --------------------------------------------------------------- There are some differences between backup and recovery of RAC environment and backup and recovery of common database. RMAN backup recovery -- backup of RAC environment database (1): /post/468/285260 RMAN backup recovery -- backup of RAC environment database (two): /post/468/287076 RMAN backup recovery -- backup of RAC environment database (three): /post/468/287617 This presentation is based on RAC environment backup to tape library and recovery from tape library. RAC backup to tape library if the file system is CLUSTER or ASM based, and then to the local hard disk backup of the little difference, only need to install the driver (tape library backup software) node can be a backup and recovery. If it is built on the bare equipment on the RAC environment, so the easiest way is to backup software, installed on the two nodes so that each node can also backup, not only simple configuration, but also can improve the efficiency of backup. $RMAN target / Recovery Manager: Release .0 - Production on, Thursday, May 17, 09:40:04 2007 Copyright (c) 1982, 2005, Oracle., All, rights, reserved. Connect to the target database: TESTRAC (DBID=4291216984) RMAN run {2 3, allocate, channel, C1, device, type, SBT, connect, sys/test@testrac1; 4, allocate, channel, C2, device, type, SBT, connect, sys/test@testrac2; 5, backup, database, plus, archivelog, delete, all, input; 6} Use the target database control file to replace the recovery directory allocation channel: C1 channel c1: sid=286 instance =testrac1 devtype=SBT_TAPE channel c1: VERITAS NetBackup for Oracle - Release 6 (2006110304) Allocated channels: C2 channels, c2: sid=291 instances, =testrac2 devtype=SBT_TAPE channels