电子分频器（Crossover）.doc

电子分频器（Crossover） In this article, Id like to share with you some tips on how to use electronic dividers. Mentioned in a stereo system in the frequency divider generally refers to the audio signal of 20Hz--20000Hz band is divided into several different frequency segments, then to the right, the corresponding power amplifier, used to drive a speaker of the corresponding audio peripherals. Since it is an electronic device for processing and distributing audio frequency signals, we usually call it an electronic frequency divider. With the function and working principle of the electronic crossover I will not say more, here I just focus on doing some easy introduction to some people more attention or often puzzled, I hope you can help! Why should we use electronic dividers? We study the acoustic sound engineer and now the development of electroacoustic equipment and technology are for one purpose: is to try to faithfully reproduce the various sources, of course to nature, all sorts of strange things various sounds completely by electro acoustic technology now is not too realistic reproduction of almost impossible to. As we all know, the sound is in the frequency range of 20Hz 20000Hz, now the range of frequency processing equipment, most of the former level audio can be achieved so that the width of the current speaker, but has become a bottleneck in the part, we expect the use of one or a few simple speaker can play out such a wide frequency close to 20Hz--20000Hz the sound is very difficult to do, because now the effective frequency range of single horn are not very wide. In view of this, electroacoustic engineers have devised speakers for different frequencies, such as: 1, subwoofer: let it work in the frequency range of about 30-200Hz. 2, low alto speakers: let it work in the frequency range of about 200-2000Hz. 3, tweeter: let it work in the frequency range of about 2000-20000Hz. So, we can use different types of speakers that work at different frequencies to configu