使用小U盘做路由（Routing using a small U disk）.docVIP

使用小U盘做路由（Routing using a small U disk） How do you reuse your discarded U disk? Today we will teach you how to rebuild the U disk and reuse it! Just a small transformation, and with our computer, you can get a powerful router, not only save the money to buy the route, and this router can not buy in the market! DD-WRT profile Every router device used in common use has its own operating system OS, which is used to set up and manage various functions of routing equipment. In fact, what we usually call upgrading router firmware is to upgrade and refresh the operating system in the routing device so as to make the routing device more powerful. DD-WRT is a Linux operating system, but essentially a third party router firmware. Its routing and network management capabilities are very powerful and are widely used in Linksys, WRT54G/GS/GL, or other 802.11g based wireless router based on Broadcom reference design. You can refresh the DD-WRT on the supported router device to make the router more powerful. Similarly, we can also let DD-WRT run independently on a computer, and we can make the router function by providing the corresponding hardware! Hardware preparation As long as a small USB idle enough, of course this is not alone as a USB router using the. However, it can be used as a very small server, portable, and with a wide variety of computers to use. At the same time, it is also necessary to add a network card or a hub for the whole machine. Install the DD-WRT x86 version Now, for the U disk, brush on the road by firmware DD-WRT. In general, you have to have a hardware device to brush the firmware, and here you have to route the firmware. As a rule, you want to brush the firmware on the router. But here we are directly updating the firmware to the U disk. DD-WRT capacity is only about 11MB, the old U disk mostly have 16MB to 128MB or so space, absolutely enough, here we in a 64MB U disk brush firmware as an example: DD-WRT X86 version of the dd-wrt-public-vga.image (hard