奥的斯3200故障代码（Otis 3200 code）.doc

奥的斯3200故障代码（Otis 3200 code） Otis TOEC-2000.300VF.3200 OCSS: button order M-1-2-2-1: event log M-1-2-2-2: mode record LMCSS: button order M-2-2-2: event log Clear the fault method: clear a single fault. Please press SHIFT+ENTER to clear the fault in the display when the ST displays the record If you are clear about all the failure records, press SHIFT+5 and then follow the instructions above OVF30: button order M-4-2-1: view current fault M-4-2-2: view storage failures M-4-2-3: clear fault record 3100 OTIS2000 LCBII: button order M-1-2-1: view event log OVF20: button order M-2-2-1: view the last time the power is connected to all events recorded now M-2-2-2: looks at all the failed erase records before the last connection is powered Fault removal method: button SHIFT+5, and then follow the instructions above to clear Otis 3200 code Failure source system implementation Code server display 2000 STM software reset board software running error, causing CPU reset 2001 STM power on reset power on reset, or press the reset button The voltage of the 2002 STM power fail 5V supply is below 2.5V., and the system is stopped during system loss 2005 STM not available some abnormal conditions are detected by MCSS, and other fault records should be checked. In addition, this record is also in emergency or repair status Fault source location reference Code server display 2100, PSR, Big, POS, slip, and the elevator running in line with the direction of the rope slippage is too large 2101, PSR, Big, neg, slip, and the elevator running in the opposite direction of the wire rope slippage is too large 2102 PSR, Pos, MES, PVT, FLT, the location of the reading is already in the flat area, but DZ has not entered, should check the photoelectric 2103 PSR Inv FLOOR COUNT floor count is invalid, the floor count and actual wells floors are not consistent, or beyond the highest or lowest floor limit. After power failure occurs in the car position is moved again after power is the fault 2104, PSR,