二次灌浆规范（Two grouting specification）.docVIP

二次灌浆规范（Two grouting specification） Chapter I General Provisions First, in order to correctly use CGM high-strength non shrinkage grouting material, to ensure the quality of the project, improve work efficiency and speed up the progress of the construction of special technical methods. Second CGM high-strength non shrinkage grouting material construction should not only comply with the provisions of the construction technology and methods, there should be in line with current code for construction and acceptance of concrete structures (GB50204), design of concrete structures (GBJ10), reinforced concrete structure technical specification (CECS25) and cement base grouting material technical specification for construction of (YB/T9261-98) the relevant provisions of the. The second chapter is the terminology and terminology Third CGM high strength non shrinkage grouting material is made of high strength material as aggregate, with cement as bonding agent, supplemented by high flow, micro expansion, anti separation and other substances prepared. Add a certain amount of water at the construction site, stir evenly after use. Hereinafter referred to as CGM grouting material The fourth weight method is in the CGM grouting material construction, the use of good fluidity of the material, in the range of grouting free flow, meet the requirements of grouting method. Fifth high funnel method is in CGM grouting material construction, only when its liquidity can not meet the requirements, the use of improved potential energy of grouting to meet the requirements of grouting method. The sixth pressure grouting method is used in grouting material construction of CGM grouting to meet the grouting requirements. The third chapter, CGM grouting material scope of application Seventh CGM grouting material range (see Table 1) Model applicable range lowest, construction temperature (DEG C) CGM-1 (common type) anchor bolt, embedded steel bar, grouting layer thickness 30mm, Delta 150mm equipment