刀偏（Knife deflection）.docVIP

刀偏（Knife deflection） Guangzhou CNC 928-TE system tool setting procedure and tool offset setting Trial cutting tool setting method: (it must be used before setting the workpiece coordinate system, and the operation process is the same as that of setting the workpiece coordinate system or executing the program after the zero point operation 1. prepare the work before the tool is made. 2., when the knife slants number is not zero, it is best to input T00, first remove the original knife, then partial knife, otherwise the system will be the original knife value and the new partial value combined calculation (only after the tool wear again when the tool needs). If necessary, you can also offset the tool with a knife. 3., on the machine tool to clip good cut workpiece, select any knife, (usually the first knife used in processing). 4. select the proper spindle speed and start the spindle. A moving tool cuts a small step on the workpiece in a manual manner. 5. move the tool to a safe position along the Z direction when the X axis does not move, and stop the spindle rotation. 6. measuring the cut step diameter, press I, X input screen display tool offset measured diameter value, press the Enter key, the screen shows T (* * X, said that the current tool number), according to the automatic calculation of X axis Enter key system tool offset value, and the calculated the partial deposit of X axis * knife knife should be partial parameters. You can view and modify the work under the knife offset mode. If it is T * X input 1 ~ 8 keys and then press the Enter button, the system calculates the offset value knife, X knife shaft will be deposited into the corresponding digital input parameters of partial area, do not press the Enter key and press the Esc key to cancel cutter deviation calculation and storage. 7. start the spindle again, move the tool in manual mode and cut an end face on the workpiece. 8. move the tool to a safe position along the X direction when the Z axis does not