壁纸施工方法（Wallpaper construction method）.docVIP

壁纸施工方法（Wallpaper construction method） The use of hard plate or nylon brush, should use soft brush from the top down blow gently, the wallpaper on the wall. 3, keep your hands clean, careful glue, do not pollute the wall surface. 4, in the post before, should be in the edge of cloth with a double-sided adhesive tape down a wall, lengthen the width of cloth edge by glue to avoid pollution. 5, if the wall surface contamination, pollution can only be to cut a wide size unit. 6, with the brush gently out of the bubble, not too hard, so as not to damage the cloth fabric, especially the yarn cloth paste, to pay special attention to the bubble near the joint, glue can not overflow. 7, to avoid the negative corner cutting and overlapping ten, not in the positive corner cut cloth, so as not to cause the positive corner wall edge of shovel. 8, if there is dust on the surface, use soft brush or brush brush. Do not wipe the stains caused by expansion can be used wet towels. Construction method of metal wallpaper: 1, metal wallpaper surface layer of gold foil or tin foil will be conductive, so be careful to avoid the power switch line. 2, because wallpaper contains moisture inside, overflow glue and then erase, also cause the possibility of oxidation of wallpaper surface. Therefore, the machine should use glue, and the correct use of protective belt. In addition, you can also consider the use of wall gluing method for construction. Construction joints as far as possible the use of pressure roller bonding, do not use scrapers, towels and so on. Especially when dealing with the angle of yin and yang. 3, because of its metallic characteristics, so can not use water or wet cloth to wipe, in order to avoid the wallpaper surface oxidation and black. Really not, use sponge gently Sassafras test. Or try wallpaper cleaner 4, gold foil wallpaper is generally thin, smooth and easy to cause reflective, rugged, fine particles of the underlying will glance, therefore the paper on the wall are