开不了机原因（Can not drive machine reasons）.docVIP

开不了机原因（Can not drive machine reasons） Simply put You can learn what the problem is by the following ways: 1, observation method, see the host power supply lamp is normal, can show normally, then can exclude power problems, otherwise change the power supply (or check the power line, socket, etc.) 2, listen to sound, according to the BIOS boot, self-test, alarm sound to judge, if there is no alarm sound, can determine two reasons (motherboard fault or graphics card fault or other card fault), can use third methods try. 3, plug method, CPU, memory, graphics cards, including other card, pull down (preferably with a brush to sweep away the dust, do not get water), use the eraser to wipe finger memory or graphics, then plug the back or another port, when wiping the memory to the same time on both sides quick plug, not side to side slowly push down. 4, replacement method, other computer normal use of the above equipment one by one to replace the past, be careful not to replace all the equipment. 5, reinstall the system, if it is a software problem (without the above phenomenon, it should be software or system problems), the best way is to reinstall the system. Common faults: First, the boot host display does not display, no alarm Two, turn on the monitor or not show, there is an alarm Three, from the Windows XP that boot interface into, and then restart again and again Four, blue screen See other questions later Analysis and solution of common trouble: One, cannot turn on the machine and have no alarm to overhaul the train of thought: The most likely cause of failure to boot and no alarm failure is the most suspect: 1. power supply; 2.CPU; 3. motherboard. Because the three pieces of hardware, as long as there is a fault, the motherboard can not start, the motherboard does not start, it will not alarm. Failure is not necessarily broken parts, poor contact is also a fault. So follow the steps below: 1., whether the power supply can be measured normally output voltage, no mea