拉伸模系数（Modulus of drawing）.docVIP

拉伸模系数（Modulus of drawing） Basic principle of drawing die (two) Three, cutting: because the mould gap is not uniform, the thickness of the plate, friction resistance range, location and direction of the mechanical properties of materials, resulting in the drawing mouth are uneven, for drawing high requirements, increase the cutting edge process. And more deep drawing is more obvious. Four, blank size calculation: According to the principle of constant volume of plastic change, the change of wall thickness in deep drawing is neglected. The principle that the blank surface is equal to the workpiece surface before and after drawing is called the equal area method. But this method of calculation is only approximate. If the thickness of the body is 0.5mm, the thickness should be calculated at the center line. When R1=R2, D= R1 = R2 D= D= D= Five 、 drawing coefficient of cylindrical parts 1. concept of drawing coefficient. The drawing coefficient refers to the ratio of D of the workpiece diameter to D of the blank diameter before drawing. M=d/D A. (M1) drawing coefficient M reflects the magnitude of material deformation during drawing, and the smaller the M, the greater the degree of deformation. B. drawing coefficient M is an important parameter in drawing process, and it is an important basis for drawing process calculation and die design. C. in actual production, in order to reduce the drawing times, M generally takes the minimum value. D. when M is small to a certain value, the outer edge of the flange will appear wrinkling, but it can increase the BHF of the pressure ring to prevent the appearance of wrinkles. E. when M is small to a certain value, tensile fracture occurs, and tensile fracture occurs at the peak of drawing force, that is, the initial stage of drawing. F. limit drawing coefficient, the minimum drawing coefficient which can be used in the condition that the dangerous section is not broken. 2. factors affecting drawing coefficient: Mechanical properties