电脑正常关机了,但是不断电源。提示你可以安全关闭计算机了（The computer was shut down, but the power was on. You can safely turn off the computer）.doc

电脑正常关机了,但是不断电源。提示你可以安全关闭计算机了（The computer was shut down, but the power was on. You can safely turn off the computer） This is the shutdown function, failure or abnormal fault. How can we solve this kind of trouble? First, the shutdown process and the cause of the failure Windows shutdown procedures in the process of the implementation of the shutdown function: complete all disk write operation, remove the disk cache, close window procedure, close all currently running programs, all protected mode drivers into a real mode. The main reason causing Windows system shutdown failure: opt out Windows sound file damage; incorrect configuration or hardware damage; the setting is not compatible with BIOS; BIOS in the advanced power management or advanced configuration and power interface is not appropriate; not in real mode for video card distribution a IRQ; a TSR program or program may not be properly closed; loading an incompatible, damaged or conflicting device driver etc.. Two 、 fault analysis and solution 1. sound file corrupted when exiting Windows First, you can make sure that the Windows sound file has been destroyed - click Start Settings control panel, and then double-click the sound. In the event box, click exit Windows. In the name, click (no), and then click OK, and then turn off the computer. If the Windows is shut down, the problem is caused by the exit sound file, in order to solve this problem, please select the following an operation: restore sound files from backup; re install provide sound files; configure Windows to not play exit Windows sound file. 2. fast shutdown is not normal The fast shutdown is a new feature in Windows 98, which can greatly reduce the shutdown time. However, this function is incompatible with some hardware and may cause the computer to stop responding if the hardware is installed in the computer. You can disable the quick shutdown. First click start, run, then type Msconfig in the open box, and then click OK (see Figure 1). Click A