应用于高速信号传输系统的多路选择器.pdfVIP

第29卷 第6期 半 导 体 学 报 Vo1．29 No．6 2008年6月 JOURNAL OF SEMICoNDUCToRS June，2008 Multiplexer Design Applied to High—Speed Signal Transmission Ca0 Hanmei ，Yang Yintang ，Cai Wei ，Lu Tiejun ，and Wang Zongmin (1 Key Laboratory of Ministry of Education fo，Wide Band-Gap Semiconductor Materials and Devices Microelectronics Institute，Xidian University，Xi’an 710071，China) (2 BeijingMicroelectronicsInstituteofTechnology，Beijing 100076，China) Abstract：A multiplexer with a low-distortion high—bandwidth analog switch is presented．The gate—to—source voltage of the switch is set by the combined on—voltage of a pMOS and an nMOS．and the difference between its gate—source voltage and the threshold voltage(VGsT)is guaranteed to be constant with input variation．Thus，the body effect is nearly canceled． Implemented in a TSMC 0．18 m CMoS process，results from HSPICE simulation show that the VG is nearly constant with an input range from 0．3 to 1．7V，and the一3dB bandwidth is larger than 10GHz；the SFDR (spurious free dynamic range)of the output is 67．11dB with 1GHz input frequency；the turn—on time is 2．98ns，and the turn—off time is 1．35ns， which indicates a break-before-make action of the multiplexer．The proposed structure can be applied to high speed signal transmission． Key words：low—distortion high speed；multiplexer；analog switch EEACC：2570 CLC number TN432．1 Document code：A Article ID：0253．4177(2008)06—1040．04 Boostrap switches can make the gate—source voltage l Intr0ducti0n