电晕An experimental investigation of corona sound in pins to plane electrostatic discharge system.pdfVIP

An Experimental Investigation of Corona Sound in Pins to Plane Electrostatic Discharge System Gabriel Nicolae Popa, Ioan Şora, Sorin Ioan Deaconu, Member IEEE, Corina Maria Diniş, and Iosif Popa Department of Electrotechnical Engineering and Industrial Informatics “Politechnica” University of Timişoara, Revoluţiei str., no.5, Hunedoara, Romania Email: gabriel.popa@fih.upt.ro Abstract-In this paper, have been studied the corona sounds in II. CORONA ACOUSTIC EMISSION an electrostatic discharge system (EDS) with pins to plane geometry in normal atmospheric pressure and temperature. For An important problem in acoustic emission signal analysis different gap distances between electrodes (2 to 5 cm), different d.c. voltage polarity (positive and negative), a.c. voltage and is the estimation of acoustic parameters. The important voltage supply (up to 10kV) the corona sounds were analyzed. components of the acoustic instrumentation system are the For the same operation conditions of EDS, the sound spectrum microphone, pre-amplifier, cable and connectors, data indicate high values under 250 Hz and 5, 11, 12, 13.5 and 19.5 acquisition system and personal computer [8,9]. kHz. Positive, negative and alternative corona have a lot of The dynamic microphones is a transducer which convert noise. The sound spectrum shows a fundamental and a number of harmonics superimpose on white noise. the acoustic signal into electrical signal.