线切割教程（Thread cutting tutorial）.docVIP

线切割教程（Thread cutting tutorial） The YH system has the following features: The upper and lower profiled surfaces are machined in taper. Taper cutting can reach 90* (+_45* slope). It can be changed into taper cutting at any time, and has the real-time compensation of the cutting point offset of the guide wheel. In theory, it can compensate the precision of 6UM. Dual CPU structure, programming control integration, processing can be programmed with the same machine Discharge state waveform display, automatic tracking, without frequency conversion regulation International standard ISO code master control Machining trajectory real-time tracking display, workpiece contour 3D modeling. Unique style of screen console, all operations are realized with the mouse, convenient and intuitive (configurable multimedia touch screen). Field data, power failure memory, power on recovery, no maintenance. With the domestic first-class YH drawing line cutting programming system. Two. Press and start the system (1) hardware installed Basic hardware environment More than 486 IBM PC or compatible dual simplex, floppy drive, VGA (or VGA single color display), more than 4M of memory, mouse (MOUSE SYSTEM). The electronic disk and control panel are loaded The system provides three circuit boards: an electronic disk, a main control board and an optically coupled middle plate. The electric board, the main board and the interface board are inserted into the host expansion slot respectively, and various signal DB25 and DB15 two sockets of the interface board are referenced (the pin definition is shown in Appendix A). (2) system startup Open the main power supply, the electric disk will automatically guide the DOS system. After the system is started, the electric disk is D disk. The C disk RAM (hard disk drive system, configuration sequence shift) Warning: not to erase files of electronic disk, but can not save the data into the electronic disk, otherwise, may cause the system to crash. (3) the YH sys