作业范例（Operation example）.doc

作业范例（Operation example） Steel concrete composite flat beam; integral floor; bearing capacity Test report Company： Graduate student： Mentors: Associate supervisor: Time: Design and calculation of floor test I. test purposes As a new type of floor slab, composite flat beam floor has been widely used in Europe, especially northern Europe in recent years. But because of its short time, relevant research results; in addition, due to the structure form in Europe, the corresponding studies are limited in the vertical bearing behavior and fire performance, while our country is in the earthquake prone country in our country with this new floor form is needed in the form of floor level bearing performance the seismic performance and further research. The main purpose of this experiment is as follows: 1., the natural frequency of the floor and the overall performance of the space (without floor loading and under normal floor loading); 2. the stiffness and deformation of the whole floor under vertical load, the distribution of the floor stress (the middle beam, the two direction, the side beam and the rib part); The deformation, stress distribution and hysteretic behavior of 3. floor under horizontal loading; 4. based on the test results, the effective width of composite flat beam and the frame model for design and calculation are put forward. Two. Subjects The experimental research object is the steel concrete deep rib composite flat beam integral floor, the floor is two spans, the total plane size is 6m * 12M, the height is 3 meters, the full scale design, as shown in figure 1. Figure 1 overall arrangement of subjects A secondary beam is arranged in the middle of the floor, and the main beam is rigidly connected with the column, the secondary beam is hinged with the main beam, and the bottom structure is shown in Figure 2, and the direction of the arrangement of the concrete rib is perpendicular to the secondary beam. Fig. 2 bottom structure of study object Using the rigid co