2010高考复习物理学案 电学实验.docVIP

2010高考复习物理学案 电学实验 This paper consists of 276970778 contributions DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. College entrance examination resource network () Your college entrance examination expert Topic fifteen I. Analysis of examples Electrical experiment works recording scholars lives and philosophical thoughts Type 1. (use of multiple meter), as shown in the circuit, 1, 2, 3, 4, 5, 6 for the connection point of the label. After the switch is closed, it is found that the small bulb is not bright. Check the circuit fault with the multipurpose ammeter, the power supply, switch, small bulb, 3 lead wires and the connection of each point in the circuit. (1) in order to detect small bulb and 3 lead wire, when the connection point 1 and 2 have been connected, the multipurpose meter shall be used. When the connecting points 1 and 2 are disconnected at the same time, the gear of multi-purpose meter shall be used. (2) in the switch case, if the measured electromotive voltage of 5, 6 between two points close to the power supply, that may be a fault (3) will be removed from the small bulb circuit, write a multimeter to detect specific steps of the small bulb whether there is fault.. Analysis: (1) in 1 and 2 two connected case, should be selected with voltage meter, in 1, 2 at the same time off, should use ohm files; (2) showed that 5, 6 points may be a fault; (3) to the 1 ohm files will be red and black pen contact resistance check whether the normal work of the ohm scale measurement of small bulb, such as infinite resistance, showed that the small bulb fault. Type 2. (multipurpose ammeter) diode. A student uses a multimeter to measure the reverse resistance of a diode. Complete the following measurements: (1) check the mechanical zero of the multi-purpose meter. (2) the red and black pen are respectively inserted into the positive and negative test jack, will choose