混凝土试块（Concrete block）.docVIP

混凝土试块（Concrete block） Article 1.0.1 This standard is formulated for the purpose of unifying the methods of inspection and assessment of concrete strength, promoting the improvement of the management level of enterprises and ensuring the quality of concrete strength. Article 1.0.2 This standard applies to the inspection and evaluation of the compressive strength of ordinary and lightweight aggregate concrete. For concrete with special requirements, the examination and assessment of its strength shall be in conformity with the relevant provisions of the current national standards. Article 1.0.3 inspection and assessment of concrete strength shall be in conformity with the relevant provisions of the current national standards in addition to the provisions of this standard. Note: according to the reinforced concrete structure design code (TJ10 - 74) engineering design, concrete strength test and evaluation using this standard, in accordance with the provisions of Appendix A, the design grade of concrete strength grade of concrete used for conversion. The strength of construction shall be converted according to the same principle. General provisions of the second chapter Article 2.0.1 the strength grade of concrete should be divided according to the standard value of compressive strength. The strength grade of concrete by the symbol C and cube compressive strength standard value (N/m square meter). Article 2.0.2 the compressive strength of standard value refers to the length of production and maintenance according to the standard methods for 150mm specimens, in the 28d age, standard test method for measuring a value distribution of the compressive strength, strength is lower than the percentage of the value of not more than 5%. Article 2.0.3 the strength of concrete shall be examined and evaluated in batches. A batch of concrete shall be made of concrete of the same strength grade, the same age, and the same process conditions and the same mixing ratio. The cast in place