Analysis on Effect of Process Parameters on （分析工艺参数对）.pdfVIP

International Journal of Science Vol.1 No.1 2014 ISSN: 1813-4890 Analysis on Effect of Process Parameters on Performance of Rectangle Box in Deep Drawing Guoying Ma1, a, Binbing Huang1, b and Chenyu Du2, c 1College of Mechanical Electronic Engineering, Shandong University of Science Technology, Qingdao 266590, China; 2School of Mechanical Automotive Engineering, Anhui Polytechnic University, Wuhu 241000, China amguoying@126.com, bkinghuang1990@163.com, c740229851@ Abstract. The mechanism of the deep drawing of rectangle box was researched, and the forming process was simulated by using the finite element analysis software Dynaform. On this basis, the influences of process parameters including stamping velocity, blank holder force, and friction coefficient on performance of rectangle box were deeply analyzed. The analysis results show that small blank holder force and friction coefficients are benefit to the shaping of sheet metal in a certain range, and usually lead to wrinkling at the same time; on the contrary, overlarge blank holder force and friction coefficients may result in cracking of rectangle box; and overlarge stamping velocity also reduce the stamping property. With the aid of finite element simulation, using repeated comparison and analysis, and selecting the most reasonable process parameters can greatly improve the efficiency of stamping production before the actual product put into production, and reduce the production costs at the same time. Keywords: Rectangle box, Process parameters, deep drawing. 1. Introduction Rectangular box as a typical representative of non-axisymmetric parts, its forming process is different from a simple ben