pg84-112(有背黑黑灰加长导芯 - global sources.pdfVIP

PRODUCT SPECIFICATION 1. 一般特性 General Characteristics 1.1 额定值(Rating Value): DC30V 0.1A. 1.2 工作温度(Work Temperature Range): -10℃ ~ 70℃ 1.3 存贮温度(Store Temperature Range): -20℃ ~ 80℃ 1.4 正常测试条件(未有特殊说明量测在以下条件进行): General test condition (Tests and measurements shall be made under the following standard conditions unless otherwise specified): 正常温度: 5℃~35℃ 相对湿度: 45%~85% RH 气 压: 8,600~10,600 帕 Temperature: 5℃~35℃ Relative humidity: 45%~85% Air pressure: 8,600~10,600 pa 2 . 产 品外观 及尺寸要求 Appearance Dimension Requirement 2.1 产品外形结构紧凑,无配合不良. The structure of product is compact, and assembly of parts has no badness. 2.2 产品塑胶部件无严重缩水、披锋、欠注、斑点、破损或变形现象. The plastic parts of product have no serious defects such as very serious shrink, scarcity, fleck, disrepair, transmutation, etc. 2.3 产品引脚和外壳无严重氧化、脏污、变形、毛刺或电镀不良. Lead feet and shell have no serious defects such as oxidation, smudge, disrepair, burr, defects on plating. 2.4 开关操作顺畅,节奏感强,无明显卡塞现象,(自锁开关锁芯锁住后,允许导芯倾斜正负 2°) Operating switch is unhindered, rhythmed , and there is not palpable clag.( After the keystoke is locked, it is normal that the keystoke tilt to one side plus or minus 2 °) 2.5 产品结构及尺寸参见产品规格图纸。 Construction and dimensions：Refer to individual product drawing. 3 . 电 气 特性 Electronic Characteristics 项 目 测试方法 测试设备 特性要求 No. Item Test Method Equipment Requirements 接触电阻 在低电流（≤100mA）条件下测试. 低电阻测试仪 3.1 Contact Measured at low current (100mA or Low Resistance 100mΩ max