如何选择气缸（How to select cylinder）.docVIP

如何选择气缸（How to select cylinder） I. selection of cylinders 1, the type of choice Select the type of cylinder correctly according to the requirements and conditions. Request cylinder arrives at a stroke without terminal impact phenomenon and the impact noise should choose a buffer cylinder; light weight, be light cylinder; Require the installation space is narrow and short stroke, optional thin cylinder; horizontal load, optional cylinder with rod; braking requirements of high precision, should not allow the lock cylinder; the piston rod rotation, with optional A cylinder with no turning function; a heat-resistant cylinder should be used in high temperature environment; a corrosion resistant cylinder should be used in corrosive environment. In harsh conditions such as dust, the piston rod is required to extend out of the end Dust cover. When no pollution is required, no oil or oil free lubrication cylinders are required. 2, installation form Depending on the location of installation, the purpose of use and other factors. In general, a fixed cylinder is adopted. In the need of continuous rotation with the work mechanism (such as lathes, grinders, etc.), should be used back Rotating cylinder. When the piston rod is required to move in addition to the straight line, the shaft pin type cylinder is used when the arc swing is needed. Special cylinders should be selected when special requirements are given. 3, the magnitude of the force That is the choice of bore. According to the magnitude of the load force to determine the thrust and tension of the cylinder output. Generally according to the external load theory, the balance condition, the required cylinder force, according to the different speed choice not The same load rate, so that the output force of the cylinder slightly margin. The bore is too small, the output power is not enough, but the diameter is too large, the heavy equipment, cost increase, and increase consumption, waste of energy. In the clip If the timing is