浅谈对变压器瓦斯保护的检验!（Elementary introduction to inspection of transformer gas protection!）.docVIP

浅谈对变压器瓦斯保护的检验!（Elementary introduction to inspection of transformer gas protection!） Elementary introduction to inspection of transformer gas protection Gas protection is the main protection for the internal faults detection of power transformers. The quality of the installation and the quality of the gas relay determines the operation effect of the gas protection. Therefore, the inspection must be carried out carefully. L, gas relay inspection, 1.l gas relay internal and mechanical part of the test (1) glass window, vent valve, probe and lead line terminal shall be intact. When the lead wire is removed, the lead terminal is prevented from following to rotate together. (2) the buoy shall be free of cracks and bumps, and the glass windows shall be intact, clear, bright and free of cracks. (3) the surface of mercury mercury contact should be clean and bright, shaking, when the flow of mercury is flexible, should not be hung on the wall and the glass electrode, the electrode and the pole tip should be bright silvery white. (4) the welding of the mercury contact post is firm, and the root is covered with a soft plastic tube; the length of the contact wire shall be suitable, and it can be bent freely without breaking the strand; the porcelain bead shall be complete, smooth and without burr. (5) mercury contact shall be firm and firm. When the contact distance is normal, the length of a pole immersed in mercury shall be no less than 4mm. When the contact of other relays is normal, the poles should be disconnected. The polarity of a coin that causes the contact to be immersed in mercury. If you do not often immersed in mercury contacts to the cathode, due to mercury vapor is a conductor of the reason, long-term operation, contact may be damaged and may even make the gas protection action. (6) movable parts should be flexible, reliable action, return no stuck phenomenon. (7) the position of the mercury contact of the float type gas relay shall be adjusted, when the floating