硒鼓加粉技巧（Toner and powder technique）.docVIP

硒鼓加粉技巧（Toner and powder technique） Toner and powder technique HP C3900A cartridges (HP 4V / 4MV / 4VC) CANON ep-b toner (CANON lbp-bx) Open a one side metal pin, outward pull hard, on both sides of the silver metal pin pulled out after the drum unit can be divided into two parts, with the drum core side is the waste powder collection pieces, with magnetic roller side is for powder storehouse.  2  replacing drum core and scraper, clean up the waste powder will waste collected pieces of gray white on either side of the photosensitive drum plastic screws on the clamp screw off, pull out white plastic clip outward, drum core can be taken out. Again taking out discharge roller, screw off the scraper on the two screw out of the scraper, clean up all the waste powder, scraper, discharge roller, photosensitive drum up according to the state before the demolition has restored (note the drum core and the white plastic clip and discharge at the ends of the roll direction cant DE). Gently turn the drum, the drums should be clean. If there is residual powder on the drum, replace the scraper in time.  Three  filling toner if your drum unit is the first time without filling toner original drum filling powder, the powder filling and dont need to clean up powder storehouse and the magnetic roller, otherwise must put powder storehouse and the toner on the magnetic roller clean. Remove the plastic cover from the powder bin, and then pour the 4V / 4VC ink powder shake into the powder bin slowly. Cover the plastic cover and gently turn the magnetic roll number circle. The magnetic roller should be able to absorb the toner evenly.  4  assembly to drum unit for powder storehouse and recover waste powder collecting parts according to the open position when the installation, plug on both sides of the metal card pin for small spring. When the toner cartridge is installed, it should push out the plate of the light-sensitive drum, and gently rotate the side gear number of the drum. The