NIKE的品质要求（NIKEs quality requirements）.docVIP

NIKE的品质要求（NIKEs quality requirements） This manual describes NIKEs quality requirements. NIKE also expects that his cooperative factory will form a positive atmosphere in the center of MQA. purpose The purpose of the daily inspection training manual for NIKE (sneaker) : ? Agree on the quality requirements of NIKE products. ? Provide a standardized training manual for NIKE and FHI. ? Ensure consistent quality standards for each plant/NLO. MQA task statement To ensure that every pair of NIKE shoes meet or exceed the quality requirements of each pair of NIKE shoes through the production process and the control of the products appearance. Ii. Inspection tools Inspection tools: ? Specification, SPEC, confirm sample shoes, AQL reports and special physical reports. ? DI inspection report, inspection board, recent internal adhesion/IDS test report and DI seal (Asian regional documents should be unified). ? Ruler, calipers, vernier calipers, bad labels and shoelace sections. Iii. Inspection area The inspection shall meet the following conditions: ? Light is very important, must be solid white fluorescent lamp; ? Check goods in the post-processing section (preferred) or bright and ventilated rooms; ? Site near or temporary warehouse after processing; ? A cabinet that can be used to confirm shoes; ? Check the relevant packing/sticker/soft bottom sticker and so on at the same time. ? The table is large enough to place the shoes for the test. ? No noise in the inspection area. The work should be neat and must not have a car needle, scissors, glass products and other things to prevent it from falling into the inner box. ? Do not repair, clean and trim in the inspection area. The inspection area is not for cleaning, trimming or trimming. The shoes are PASS or FAIL depending on the quality of the shoe when opening the inner box. Iv. The DI does audit procedures ? The daily DI is carried out in the processing line. ? The temporary warehouse shall be kept in accordance with the proces