钢筋质量通病（Quality of reinforcing bars）.docVIP

钢筋质量通病（Quality of reinforcing bars） Analysis and control of common quality of reinforced concrete piles Support yaogo, support originality With the improvement of building seismic requirements, and promote the use of new wall materials, the traditional brick housing structure has been gradually replaced by a frame structure, the vertical bearing component for building structure is all concrete column is important. But by yibin several times on site quality inspection and quality supervision and inspection, we found that the current situation of quality of concrete column is concrete beam slab far worse, some concrete quality common fault in the concrete pillar are more concentrated reflection, needs more attention from all of us. I. analysis of common causes of common column quality (a) concrete strength is low, poor uniformity, lower than the same grade of concrete beam and slab, the main reason with grades of concrete beam and slab, the main reason is that changed mixture ratio, water cement ratio is big, big slump; Not enough mixing; Vibratory unevenly; Premature removal of mold, curing not in place, early dehydration surface loose. (2) the phenomenon of soft roof of concrete column, the top of the cylinder has more mortar and less gravel, and the surface is loose and cracked. The main reason is that the concrete water ash is bigger than large, the slump is large, the speed of the ramming is too fast, the unstratified water is eliminated, the water is not eliminated at the top level and the water is not eliminated. (3) honeycomb and holes of concrete. The main reason is that the proportion is incorrect; The concrete mixing time is short, not stirred evenly, too much material at a time, vibrate uncompacted; Unlayered casting, concrete segregation, template pore unblocked good, or template support is not strong, vibratory, the template shift leak. (4) concrete, the main reason is that when the concrete is poured, the block of the steel is shifted, or the pad is too